DHC - 60.7 - AM/FM Radio

The Basic Manual explains the method using automatic tuning. For manual tuning, see the Advanced Manual.

1. Press the Tuner button on the main unit several times to select either "AM" or "FM".
   
2. Press Tuning Mode on the unit, so that the "AUTO" indicator on the display lights.
   
3. Press Tuning on the unit.
   The automatic tuning to a radio station starts. Searching stops when one is tuned. When tuned into a radio station, the " " indicator on the display lights. The "FM STEREO" indicator lights if the radio station is an FM radio station.

Registering a radio station: You can register up to 40
of your favorite AM/FM radio stations.

1. Tune into the AM/FM radio station you want to register.
2. Press Memory on the unit so that the preset number on the display flashes.
3. Repeatedly press Preset on the unit to select anumber between 1 and 40 while the preset number is
   flashing (about 8 seconds).
4. Press Memory again on the main unit to register the station. When registered, the preset number stops flashing. To select a preset radio station, press Preset  on the main unit or CH +/- on the remote controller.

To delete a registered preset station, press the Preset button on the main unit, select the preset number you want to delete, then while holding down the Memory button, press the Tuning Mode button. When deleted, the number on the display goes off.

AM/FM frequency step setting
It may be necessary for you to change the frequency step to tune the radio in your area. Change the step
with the following procedure. Note that when this setting is changed, all radio presets are deleted.

1. After pressing RCV on the remote controller, press Setup.
2. Select "6. Hardware" with the cursor and press Enter.
3. Select "Tuner" with the cursor and press Enter.
4. Select "AM/FM Frequency Step" (North American models) or "AM Frequency Step" (Australian
   models) with the cursor and select the frequency step for your area.